|
Assemblies of PE microducts (m/d) (3, or 5 or 8mm), each with low friction performance. Each assembly (tube bundle) is surrounded by an overlapped aluminium water barrier layer. Over this and bonded to it is a flexible sheath of black outdoor PE. These lightweight and flexible products are intended for direct installation into waiting duct, but not for direct burial or aerial use.
Please consult the corresponding datasheet for more information.
 EMTELLE DI Assemblies 3mm, 5mm and 8mm (169.09 kB)
|
|
|
Assemblies of PE microducts (m/d)(3, or 5 or 8mm), each with low friction performance. Each assembly (bundle) is surrounded by water-block material, both between m/ds and as an overlapped tape. Over this is a flexible black sheath of PE. These lightweight and flexible products are intended for direct installation into waiting duct, but not for direct burial or aerial use.
When using Emtelle Direct Install metal-free products adequate provision must be made to take account of all strain which may be caused by installation forces, practices and procedures, thermal changes, heat reversion or any other reasonably foreseeable force applied to the product. Emtelle recommend that suitable installation practices and procedures be used and that a suitable clamping or restraint method be adopted in all instances.
Pleae consult the corresponding datasheet for more information.
EMTELLE DI Metal-Free 3mm, 5mm and 8mm (801.37 kB) |
|
|
Metal-free assemblies of PE microducts (10 or 12mm), each with low friction performance. Each assembly (bundle) is surrounded by an overlapped metal-free layer that reacts to help block water movement. Over this is a tough sheath of black outdoor PE. These lightweight products are intended for direct installation into waiting duct, but not for direct burial or aerial use.
When using Emtelle Direct Install metal-free products adequate provision must be made to take account of all strain which may be caused by installation forces, practices and procedures, thermal changes, heat reversion or any other reasonably foreseeable force applied to the product. Emtelle recommend that suitable installation practices and procedures be used and that a suitable clamping or restraint method be adopted in all instances.
Please consult the corresponding datasheet for more information.
EMTELLE DI Metal-Free 10mm and 12mm (133.81 kB) |
|
|
|
|
|
PRODUCTS 